Installation guide

'Hardware Setup' | 18
RADVISION | Installation Guide for SCOPIA XT1000 Version 2.0
Figure 2-13 Connecting the Standard Camera
Connecting an Optional Camera
The optional camera kit contains a camera, remote control, and power supply. The kit does not
contain cables since the optional camera location and distance from the Codec Unit varies
significantly across installations.
Use the Sony Camera when high motion 720p60 capture is required. This camera also supports up
to 40x digital zoom.
There are two ways of controlling the optional camera:
• Using the remote control provided in the optional camera kit.
• Using the XT1000 Remote Control Unit. In this case, you must connect a VISCA Cross cable
between the Standard Camera VISCA OUT and the optional camera VISCA IN. The cable will
transfer commands from the Codec Unit to the cameras. (See Using Optional Cameras with
the XT1000 Remote Control Unit page 20).
Note: CAUTION: Remove the camera stabilizing cartons before applying power to the camera.