Installation guide

2
'Hardware Setup' | 7
RADVISION | Installation Guide for SCOPIA XT1000 Version 2.0
Hardware Setup
Safety Regulations
For detailed safety information consult the SCOPIA XT1000 Safety Instructions leaflet enclosed in
the delivery package.
Prerequisites
Room Setup
Set up the conference room to enjoy the virtual meeting.
SCOPIA XT1000 can receive the Infra-Red (IR) command of the Remote Control Unit via:
1. The Codec Unit IR receiver
2. The IR receiver of the XT1000 Standard Camera or the Sony Camera. In this case the Remote
Control Unit sends the command to the Codec Unit using the VISCA connection. The position
of the Codec Unit in the conference room is not important for receiving the signal from the
Remote Control Unit. But it is important to connect the main camera correctly to the Codec
Unit via the VISCA Cross cable.
Place the Codec Unit anywhere within 5 meter reach of the camera cables. Leave enough space
for air circulation and for connecting cables easily.
Place the camera(s) in a position to ensure eye contact between local and remote participants.
Recommended position is either directly below or directly above the monitors, in central position,
at a distance which enables capture of the entire table.
Place the Microphone Pod at the center of the table. To help with echo cancellation, we
recommend to position the Microphone Pod as far as possible from loudspeakers and other noise
sources (e.g.:computer fans).