Specifications

Figure 8: Multimedia Ports Area
4. Configure your port range (using any values between 2326 and 65535) by doing the
following:
a. Enter the base port value in the Lowest Multimedia Port field.
b. Enter the upper port value in the Highest Multimedia Port field.
5. Select OK or Apply.
Limiting the TCP Port Range for H.245/Q.931 on the Scopia XT Desktop
Server
About this task
The Scopia XT Desktop Server has designated ports 1024-65535 for TCP for H.245 and Q.931
signaling. To provide additional security for your firewall, you can limit this range.
For each conference, the Scopia XT Desktop Server uses 2 ports. In addition, add extra ports for:
•
Add 2 ports for each participating Scopia XT Desktop Client client.
•
Add 1 port per conference when presenting using the content slider.
Procedure
1. Navigate to <Scopia XT Desktop install_dir>\ConfSrv.
2. Edit the config.val file as follows:
a. Locate the text 1 system.
b. At the bottom of that section, add two lines:
2 portFrom = <lowest range limit>
2 portTo = <highest range limit>
Where <lowest range limit> is the base port of your port range and <highest
range limit> is the upper value of your port range.
3. Access the Windows services and restart the Scopia XT Desktop - Conference Server
service.
Deployment Guide for Scopia XT Desktop Server for IP Office
Version 8.2.1
Planning your Scopia XT Desktop Server Deployment | 18