Instruction manual

RADVISION |SCOPIA Elite 5000 Series MCU Safety Guide Performing Service and Maintenance Procedures| 12
Performing Service and Maintenance Procedures
General Information
Safety instructions
Before handling the board, read the instructions and safety guidelines in the following pages to prevent damage to
the product and to ensure your own personal safety.
CAUTION
Do not attempt to service the system yourself, except as explained in the SCOPIA Elite 5100/5200
Series MCU Installation Guide or Administrator Guide. Follow installation and maintenance
instructions closely.
• Always use caution when handling or operating the chassis. Only qualified, experienced, authorized
electronics service personnel should access the interior of the unit. The power supplies produce high
voltages and energy hazards, which can cause bodily harm.
• Use extreme caution when installing or removing components. Refer to the installation instructions in the
SCOPIA Elite 5100/5200 Series MCU Installation Guide for installation procedures. If you have any
questions, contact RADVISION Technical Support.
WARNING
High voltages are present inside the chassis when the unit's power cord is plugged into an
electrical outlet. Turn off system power, turn off the power supply, and then disconnect the
power cord from its source before removing the chassis cover. Turning off the system power
switch does not remove power to components.
WARNING
This product contains static-sensitive components and should be handled with care. Failure to
employ adequate anti-static measures can cause irreparable damage to components.