Installation guide

Performing the MCU Initial Configuration | 45
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
c. Locate the CLI section and select More (see Figure 5-13 on page 44).
Figure 5-14 CLI Section
Step 2 Enter the h245baseport command in the Command field.
Note: To see the current port value, select Execute.
Step 3 Modify the port value in the Value field.
Step 4 Select Execute.
Step 5 Select Close.
Configuring the HTTP Port on the SCOPIA Elite MCU
The SCOPIA Elite MCU 5000 Series has designated port 80 for HTTP. You can configure a different
port to use HTTP if necessary in your environment.
Procedure
Step 1 Navigate to the MCU Advanced Commands section by doing the following:
a. Select the icon.
b. Select Advanced parameters.
c. Locate the CLI section and select More (see Figure 5-13 on page 44).