Installation guide

Performing the MCU Initial Configuration | 31
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Figure 5-2 Setting the IP Address
Step 12 Enter the subnet mask without leading zeros at the Subnet mask prompt and then press Enter.
Step 13 Enter the IP address of the router associated with the segment in which the unit will be installed
at the Default Router prompt and press Enter.
Step 14 Press Enter at the Preferred DNS prompt.
Step 15 Press Enter at the Alternate DNS prompt.
Step 16 Press Enter at the DNS suffix prompt.
Step 17 Enter Y.
Step 18 Enter Q at the prompt and press Enter.
Step 19 Allow the unit to complete the reboot process. A new emulator session begins.
Step 20 Close the terminal emulator session.