Installation guide

Setting up the MCU | 28
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Step 2 Connect a network cable to the left Ethernet connector on the front side of the device (see
Figure 4-14 on page 27)
Note: Use both Ethernet connectors for dual-NIC deployments. A dual-NIC MCU raises security
by using different subnets for media and management. Use the left Ethernet connector
for management and the right connector for media. For more information, see the
Configuring a Dual-NIC MCU section in the Installation Guide for the SCOPIA Elite MCU.
Step 3 Connect a computer to the device with a serial cable. Connect one end to the PC serial port and
the other end to the MCU Serial connector. This connection is required for local configuration and
maintenance.
Note: Do not connect a screen or a keyboard to the MCU.