Installation guide

Setting up the MCU | 27
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
b. On the rear side of the device, plug in the power cable into the AC power connector (see
Figure 4-13 on page 27).
Figure 4-13 Rear panel of the device
c. Plug in the other end of the power cable into the mains.
d. Power on the device using the On/Off switch on the rear side of the device (see Figure 4-13
on page 27).
Figure 4-14 Device front panel
e. Turn on the power distribution unit (PDU).