Installation guide

Setting up the MCU | 25
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Procedure
Step 1 Lift the device according to the instructions in “Complying with MCU Lifting Guidelines” on
page 19.
Step 2 Slide the device onto the shelf until the holes on the device’s brackets align with the cage nuts
you mounted previously. See Figure 4-11 on page 25.
Figure 4-11 Sliding the MCU onto the shelf
Step 3 Insert the four remaining screws you set aside through the bracket holes into the cage nuts in the
rack. Using the Allen wrench tighten the screws to secure the device to the front posts. See
Figure 4-12 on page 26.