Installation guide

Setting up the MCU | 22
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Attaching Brackets to the MCU
The brackets serve to secure the device to the rack’s front posts.
Procedure
Step 1 Position the device on a flat, horizontal surface. Make sure the device front panel faces toward
you.
Step 2 Unscrew the four black Phillips screws on either side of the device. See Figure 4-7 on page 22.
Figure 4-7 Removing the Phillips screws on the side panel
Step 3 Attach the brackets on each side of the device side panel with the Phillips screws. See Figure 4-8
on page 22. Use the Phillips screws of the accessories kit, as they have the same color as the metal
of the bracket.
Figure 4-8 Aligning the bracket with the MCU front panel