Installation guide

Setting up the MCU | 21
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Checking the Accessories Required for Mounting
Check you have the accessories necessary for mounting the device (see Figure 4-6 on page 21):
• 2 mounting brackets (left and right)
• 4 cage nuts (M6) each with its hexagon socket cap screw (M6x10, DIN 7984)
• 8 Phillips screws.
Note: Make sure you have a ruler, an Allen wrench (4 mm diameter), and a screwdriver (Nr. 1 tip) ready
to hand before you start the setup.
Figure 4-6 Accessories required for mounting