Installation guide

Setting up the MCU | 18
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.7
• Find a space on the rack which is at least 7 empty square holes in height on the rack posts.
The MCU takes up 3 holes (1U) on the posts. You need at least 2 additional holes to slide the
device into the rack.
See Figure 4-3 on page 18.
Figure 4-3 Height of the MCU in the rack
• To mount the MCU between two posts, the width between the inner sides of the two posts
must be at least 17.7 inches (45 cm). See Figure 4-4 on page 18.
Figure 4-4 Width between inner sides of posts