Specifications

Maintaining the SCOPIA Elite 5100 Series MCU | 40
RADVISION | Administrator Guide for SCOPIA Elite 5100 Series MCU Version 7.7
Configuring the TCP/UDP/TLS Port for SIP on the SCOPIA Elite MCU
The SCOPIA Elite MCU 5000 Series has designated ports 5060 and 5061 for SIP. You can configure
a different port to use SIP (for example, if port 5060 or 5061 is busy).
Procedure
Step 1
Navigate to the MCU SIP Protocol section by selecting Configuration > Protocols.
Step 2 Locate the Enable SIP protocol section and select More (see Figure 3-32 on page 40).
Figure 3-32 SIP Port Configuration
Step 3 Do one of the following:
• If your SIP server or Registrar is not configured with TLS, enter the port value in the Local
signaling port field.
• If your SIP server or Registrar is configured with TLS, enter the port value in the Local TLS
signaling port field.
Note: If your SIP server or Registrar is configured with TLS, you can also configure the port value for
TCP/UDP traffic by modifying the Local signaling port field.
Step 4 Select Apply.