Installation guide

Performing Initial Configuration of the SCOPIA Elite MCU | 25
RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.5
Procedure
Step 1 Connect the network cable of the management subnet to the left ethernet port only, and activate
the unit.
Figure 4-8 Two ethernet connectors of the SCOPIA Elite MCU
Note: Do not connect the media subnet cable until the MCU has been reset at the end of this
procedure.
Step 2 Access the MCU in a web browser and login.
Step 3 Select the Configuration tab.
Step 4 Select the Advanced IP (Dual-NIC) Configuration check box to expand that section of the page.
Figure 4-9 Dual-NIC configuration for management and media subnets
Step 5 Under Management Interface, enter the IP information for the management subnet:
a. Enter the MCU’s IP address on the management subnet in the Primary IP address field.