Installation guide

Setting up the SCOPIA Elite 5100 Series MCU | 10

RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.5

Procedure

Step 1 Lift the Cisco Unified Videoconferencing 5000 Series MCU chassis according to the instructions in

the Chassis Lifting Guidelines page 7.

Step 2 Ensure the front of the chassis faces front and place the chassis on the shelf brackets.

Step 3 Locate one person at the front of the rack and one at the rear.

Step 4 Position the chassis so that the "L" brackets are inserted into the chassis mounting brackets.

Step 5 While one person supports the weight of the chassis, the other person must adjust the "L" brackets

to fit tightly into the chassis brackets.

Step 6 Slide the chassis toward the front of the rack until the front of the chassis mounting brackets

contact the rear of the center posts.

Step 7 Using the rack screws, attach the front of the mounting brackets to the front of the center posts.

Step 8 Tighten all screws.

Attaching the System Ground

Before connecting power or turning on power to the SCOPIA Elite 5100 Series MCU, it strongly

recommend that you provide an adequate chassis ground (earth) connection for the chassis.

You must use size 18 AWG (1 mm

) or larger wire, and an appropriate user-supplied ring terminal.

Note: This equipment must be grounded. Never defeat the ground conductor or operate the equipment

in the absence of a suitably installed ground conductor. Contact the appropriate electrical

inspection authority or an electrician if you are uncertain that suitable grounding is

available.Connect the AC power receptacle to the AC power source with the provided power cable.

Shelf Mounting the SCOPIA Elite 5100 Series MCU

During the shelf mounting procedure you must secure the MCU in its position on a shelf to prevent

it from moving around on the shelf or falling.

Procedure

Step 1 Verify that the shelf you want to use is properly mounted and secured.

Step 2 Verify that the shelf can support the MCU weight.

Step 3 Fix the integral mounting brackets of the MCU to the shelf rails.