Installation guide

Setting up the SCOPIA Elite 5100 Series MCU | 8

RADVISION | Installation Guide for SCOPIA Elite 5100 Series MCU Version 7.5

Installing the Brackets

You must install the side rails into a rack with square or round holes:

Figure 3-2 Mounting Holes on Rack

Note: If you mount the side rails in holes that are not vertically aligned from side to side, you can damage

the unit.

Procedure

Step 1 On the left and right uprights, determine the vertical position in the rack where the unit will be

installed.

Step 2 The unit height is 1U. Measure the distance between mounting holes and insert the cage nuts

accordingly.

Step 3 Ensure the port adapter latch is in the locked position and the screw is tightened.

Step 4 Ensure the rack breaks are locked or the rack is stabilized.

Rear Front

207525

1 RU