User guide

Configuring the SCOPIA Gateway 85
Configuring Gateway Settings
CONFIGURING BASIC
GATEWAY SETTINGS
In the Basics section of the Settings tab, you can set the Gateway identifier,
which is the name that the Gateway uses when registering to a gatekeeper and
when dialing to endpoints.
 Procedure
1 In the Gateway interface, on the sidebar, click Gateway (if not already
selected).
2 Click the Settings tab.
3 Click Basics (if not already selected).
4 In the Gateway Identifier field, enter the Gateway identifier.
CONFIGURING IP
CONNECTIVITY
SETTINGS
In the IP Connectivity section of the Settings tab, you can select the IP
connectivity mode in which the Gateway operates, set the address of the
gatekeeper with which the Gateway registers, and define the way in which the
Gateway interacts with the gatekeeper.
You can configure the IP connectivity mode in the following two ways:
 Using a gatekeeper—The Gateway registers with a gatekeeper and uses
the gatekeeper for every call (see Configuring the Gateway to Register
With a Gatekeeper on page 86).
 Peer-to-Peer—The Gateway connects directly to a peer device without
the need for a gatekeeper (see Configuring the Gateway for Peer-to-Peer
IP Connectivity on page 88). Peer devices include
RADVISION H.324/M
Gateways for mobile applications.
Caution Changing the IP connectivity mode setting causes the Gateway to reset.