User guide

84 SCOPIA 400/1000 Gateway User Guide
Configuring Gateway Settings
REFRESHING
GATEWAY STATUS
You can refresh the information that appears in the Status tab.
 Procedure
1 In the Gateway interface, on the sidebar, click Gateway (if not already
selected).
2 Click the Status tab (if not already selected).
3 On the toolbar, click Refresh.
The information that appears in the Status tab is now refreshed.
CONFIGURING
GATEWAY
S
ETTINGS
In the Settings tab of the Gateway interface, you can configure gatekeeper and
Interactive Voice Response (IVR) addressing, the type of connection to the IP
network, dialing delimiters, media encoding/decoding protocols, Quality of
Service levels, which events cause the Gateway to send SNMP traps, Gateway
resource levels for T.120 enabled and audio transcoded video calls, security
settings, and advanced settings such as load balancing support.
The following topics discuss the settings you can configure in the Settings tab:
 Configuring Basic Gateway Settings on page 85
 Configuring IP Connectivity Settings on page 85
 Configuring IVR Settings on page 92
 Configuring Outgoing Call Delimiters on page 94
 About Codecs on page 95
 Configuring Codecs on page 97
 Configuring ISDN Channel Bonding Settings for Downspeeding on
page 98
 Configuring Quality of Service on page 99
 Configuring Alert Indications on page 101
 Configuring Gateway Resources for Calls on page 109
 Configuring Gateway Encryption on page 110
 Configuring Advanced Settings on page 111
 About DTMF Settings on page 117
 Configuring Advanced Commands on page 121