User guide

Configuring the SCOPIA Gateway 79
Configuring SCOPIA 400 Chassis Parameters
Related Topics
 Setting Chassis Temperature Thresholds on page 79
 Refreshing the System Section on page 79
SETTING CHASSIS
TEMPERATURE
THRESHOLDS
You can set critical and safe threshold values for the SCOPIA chassis.
 Procedure
1 In the Gateway Administrator interface sidebar, click System.
2 In the High field, enter a value in Celsius for the critical temperature
threshold.
The ALARM and TEMP LEDs illuminate red when the operating
temperature inside the chassis rises above this value.
3 In the Low field, enter a value in Celsius for the safe temperature
threshold.
The TEMP LED illuminates green to indicate normal operation.
The TEMP LED blinks green when the reading is inaccurate. If the LED
blinks green for a few seconds and then illuminates continuously, no
action is necessary. If the LED blinks green continuously, contact
RADVISION Customer Support.
4 Click Upload to save the changes.
5 Click Refresh to refresh the System section.
REFRESHING THE
SYSTEM SECTION
You can refresh the information that appears in the System section to provide the
latest Gateway status.
 Procedure
1 In the Gateway interface, make sure that System is selected on the
sidebar.
2 Click Refresh.