User guide

56 SCOPIA 400/1000 Gateway User Guide
Connecting the Gateway to a Power Source
SIGNALING INTERFACE
P
IN LAYOUT
This section illustrates the pin layout for the Serial Gateway signaling cable
connector.
DB-25 C
ONNECTOR Figure 2-19 shows the DB-25 pin layout.
Figure 2-19 DB-25 Pin Layout
CONNECTING THE
G
ATEWAY TO A
P
OWER SOURCE
This section describes how to supply power to the Gateway. The Gateway is
equipped with an autoswitching power supply that supports 100-240 VAC at
50/60 Hz.
 Procedure
1 Plug a power cord into the power socket on the rear panel of
the Gateway.
2 Connect the power cable to a grounded AC outlet.
3 Turn the power on.
2
1
3
5
7
9
11
13
4
6
8
10
12
14
15
16
17
18
19
20
21
22
23
24
25