User guide

40 SCOPIA 400/1000 Gateway User Guide
Connecting Serial Lines to the Gateway
CONNECTING
SERIAL LINES TO
THE GATEWAY
You can connect the Gateway S40 SP to four serial lines that may support
different physical standards (V.35, RS-449 or EIA-530). The system is capable
of recognizing the type of cable connected.
 Procedure
1 Connect the DB-60 male connector of the cable to the DB-60
female connector of the unit.
2 Tighten the screws.
3 Connect the remote connectors (V.35, RS-449, EIA-530 and
RS-366) to the connectors or the connecting cable of the
remote equipment
SERIAL GATEWAY
CABLE
C
ONNECTIONS AND
P
IN-OUTS
This section describes the DTE and DCE cables that you can use with the
RADVISION
Gateway S40 SP including the following topics:
 Physical Description of DTE Cables on page 40
 Physical Description of DCE Cables on page 46
 Data Interface Cable Pin-out Configurations on page 50
 Data Interface Pin Layouts on page 52
 Signaling Interface Cable Pin-out Configuration on page 55
 Signaling Interface Pin Layout on page 56
PHYSICAL
D
ESCRIPTION OF DTE
C
ABLES
This section describes the following DTE cables supplied with the RADVISION
Gateway S40 SP:
 V.35/RS366-DTE on page 41
 EIA449/RS366-DTE on page 42
 EIA530/RS366-DTE on page 43
 EIA530/RS366-DTE- LOS on page 44
 EIA530A/RS366-DTE on page 45
 KIV7/RS366-DTE on page 46