User guide

Installing the SCOPIA Gateway 39

Connecting the Gateway to the Network

6 In the Password field, type the software password.

The default value is null.

Note To view the software components that will upgrade, click Customize.

The Customize dialog box appears. If you do not want to upgrade a

component, deselect it.

7 Click Upgrade.

The upgrade process takes a few minutes. After the upload

completes, the Upload Complete Message dialog box appears.

8 Click OK.

CONNECTING THE

GATEWAY TO THE

ETWORK

The SCOPIA Gateway can connect to the LAN only through the front panel.

The Gateway supports a 10/100BaseT, full-duplex Ethernet interface through an

RJ-45 connector.

 Procedure

1 Connect the supplied LAN cable from your network hub to the

10/100BaseT Ethernet port on the front panel of the Gateway.

The 10/100BaseT port accepts an RJ-45 connector.

2 Connect a separate ISDN or serial line to each PRI or serial

port in the rear panel of the Gateway. The port accepts an

RJ-45 connector.

CONNECTING PRI

INES TO THE

ATEWAY

You must connect a PRI line to at least one Gateway P20 SP port. The Gateway

supports T1 and E1 PRI configurations.