User guide

Installing the SCOPIA Gateway 37
Initial Gateway Configuration
8 At the prompt, type N to configure default network port values
and press Enter.
9 At the Enter IP address for default interface prompt, type
the IP address you want to assign to the Gateway and press
Enter.
Caution Do not use leading zeros in the IP address.
10 At the Enter Default Router IP Address prompt, type the IP
address of the router associated with the segment in which the
unit will be installed and press Enter.
Caution Do not use leading zeros in the IP address.
11 At the Enter IP Mask for default device prompt, type the
subnet mask without leading zeros, and then press Enter. If a
subnet mask is not used, press Enter.
12 Allow the unit to complete the reboot process. A new emulator
session begins.
13 Close the terminal emulator session.
CHANGING THE
C
ONFIGURATION TOOL
L
OGIN PASSWORD
You can use the terminal emulator to change the default password of the default
login user before others can use the Gateway interface.
 Procedure
1 Start a terminal emulator session for the Gateway.
2 Press the RST button on the front panel of the Gateway.
After 60 seconds, a new terminal emulator session begins on the
computer monitor.
3 After the second VxWorks banner scrolls across the screen, the
following message appears: “Press any Key to start the
configuration.”