User guide

Installing the SCOPIA Gateway 31

Installing the Gateway

INSTALLING THE

ATEWAY MODULE

This section describes how to install the SCOPIA Gateway module in the

SCOPIA 400 chassis and in the SCOPIA 1000 chassis.

Warning You must install the RTM module before you install the Gateway

module. Inserting an RTM module in the rear of the chassis when a Gateway

module is already installed in the same position at the front of the chassis may

damage the chassis.

 Procedure

1 On the front of the chassis, loosen the screws of the blank

panel covering the slot into which the Gateway module is to be

installed.

2 Remove the blank panel.

3 Remove the new Gateway module from the antistatic bag.

4 Press the red buttons and open the handles of the Gateway

module.

5 Align the edges of the Gateway module with the chassis guide

rails.

6 Slide the Gateway module into the chassis until it stops (see

Figure 2-5 for the SCOPIA 400 chassis).

7 Use even pressure to push the module further into the slot.

Caution Do not force the connection. Forcing the connection can bend or

damage the pins in the connector inside the chassis.

Note If you are installing the Gateway module and the power to the chassis

is on, the SWAP RDY LED on the module front panel turns blue when you

slide the module into the chassis as far as it will go. This means that you can

secure the module safely. The LED turns off when the handles are closed.