User guide

28 SCOPIA 400/1000 Gateway User Guide
Installing the Gateway
INSTALLING THE
GATEWAY
This section describes how to insert a Gateway into the SCOPIA 400 chassis
and into the SCOPIA 1000 chassis.
Before You Begin
Note the following:
 The SCOPIA 400 chassis has four slots. You can install the SCOPIA
Gateway in any of the slots.
 Insert the Gateway in the top slot at the front of the SCOPIA 400
chassis to view status and identification information via the System
web user interface.
 The SCOPIA 1000 chassis has 18 payload slots. You can install the
Gateway in any of slots 3-20.
The SCOPIA Gateway has two components that you must install in the chassis:
the SCOPIA Gateway module and the corresponding Rear Transition Module
(RTM), as indicated in Table 2-5.
The Gateway module installs in the front of the chassis and provides ISDN or
serial functionality. The RTM installs in the rear of the chassis and provides the
physical interface for the ISDN or serial line. You must install these modules in
corresponding slots in the chassis. That is, if you insert the Gateway module in
the top slot in the front of the chassis, you must insert the RTM in the top slot in
the rear of the chassis.
Warning
 During this procedure, wear grounding wrist straps to avoid ESD damage
to the blade. Do not directly touch the backplane with your hand or any
metal tool, or you could shock yourself.
Table 2-5 Identifying RTM Boards
Gateway Corresponding RTM
Gateway [gw-P25/M] Dual PRI RTM board
Gateway P20 SP Dual PRI RTM board
Gateway S40 SP Quad Serial RTM board