User guide

Installing the SCOPIA Gateway 21
Preparing for Installation
PREPARING FOR
INSTALLATION
This section describes the requirements for installing the RADVISION Gateway
on the SCOPIA 400 platform and on the SCOPIA 1000 platform.
ON THE SCOPIA 400
P
LATFORM
This section describes the requirements for installing the Gateway in the
SCOPIA 400 chassis. For more information, see the SCOPIA 400 Platform
Guide. The requirements are as follows:
Warning During this procedure, wear grounding wrist straps to avoid ESD
damage to the blade. Do not directly touch the backplane with your hand or any
metal tool, or you could shock yourself.
 SCOPIA 400 chassis
 Proper clearance at the sides of the unit to allow adequate ventilation,
and at least 20 cm clearance at the back of the chassis to allow access
to the boards and cable connections
 A PC with a serial port and terminal emulation software to assign the
Gateway an IP address
 Dedicated IP address for the Gateway
 The IP address of the router the Gateway will use to communicate
across the network
 The IP address of the H.323 gatekeeper with which you want the
Gateway to register
 Available IP network ports on the switch for the SCOPIA 400 chassis
 A grounded AC power outlet
 A 10BaseT or 100BaseT LAN cable
 Ambient room temperature range of 32
o
to 104
o
F (0
o
to 40
o
C)
 Non-condensing relative humidity range of 5% to 85%