User guide

18 SCOPIA 400/1000 Gateway User Guide
Physical Description
PHYSICAL
DESCRIPTION
This section provides a physical description of the Gateway modules and their
corresponding RTMs.
GATEWAY MODULE The Gateway module has a 10/100BaseT Ethernet port on the front panel that
uses an RJ-45 connector to connect to the network. There is an asynchronous,
9-pin serial port that you can use with a hyperterminal program to configure and
monitor the module.
Figure 2-1 shows the front panel components of the Gateway module. Table 2-1
describes these components.
Figure 2-1 Gateway Front Panel
Table 2-1 Front Panel Components
Component Description
ETHERNET connector An RJ-45 connector that provides the primary Ethernet
connection for the IP network port.
SERIAL connector A DB-9 connector that allows you to connect a PC
terminal for local configuration.
RST button Allows you to reset the Gateway manually.
GK LED Lights green when the Gateway is registered with a
gatekeeper.
CD LED Lights green when at least one Gateway port connection is
online.
ACT LED Lights green to indicate that there are active calls in the
Gateway.
ALRM LED Lights green to indicate that an error has occurred and the
Gateway requires resetting.