User guide

178 SCOPIA 400/1000 Gateway User Guide
Introduction
INTRODUCTION The RADVISION Audio Message Utility is an interactive GUI that enables you to
record and replace messages and upload new messages to the call routing
mechanisms in
RADVISION devices.
Default built-in messages are in English. The
RADVISION Audio Message Utility
allows you to record new messages in a different language or with different
content to suit your requirements. The
RADVISION Audio Message Utility also
enables you to replace and upload new messages to the target
RADVISION
device.
There are two ways of using the
RADVISION Audio Message Utility. The
standard utility functions enable you to play, record or replace messages. The
Express Setup guides you through the recording, replacing and upload procedure
for each message.
Before You Begin
Before you can record, play and upload messages to the target RADVISION
device, you must
 Save recorded messages as WAV files.
 Know the IP address of the target device.
ABOUT GATEWAY
CALL ROUTING
The RADVISION Audio Message Utility provides audio messages for the call
routing mechanism in
RADVISION Gateways. The call routing mechanism
initiates a series of voice messages that allow you to make choices and respond
via the keypad through dial tones (DTMF).
The routing mechanism enables you to dial through the
RADVISION Gateway to
an IP network-based H.323/SIP/RTSP terminal when you do not know the
extension number of the destination terminal.