User guide

146 SCOPIA 400/1000 Gateway User Guide
Configuring Port Settings
3 Click Advanced ISDN.
4 Select an ISDN information element and click Delete.
CONFIGURING PORT
CALL POLICIES
In the Call Policies section of the PRI Port or Serial Port tabs, you can configure
the incoming call routing methods available in the Gateway for each specified
port. You can define each port with different settings.
 Procedure
1 In the Gateway interface, on the sidebar, click Gateway (if not already
selected).
2 Click the applicable PRI Port or Serial Port tab.
3 Click Call Policies.
4 Select the Same as Port check box to duplicate call policies settings
from another Gateway port that you choose from the field. When
selected, you cannot modify any settings in this section.
Note This option is unavailable in Gateways that support only one PRI port.
5 In the Enable inbound routing methods section, you can select incoming
call routing methods in the following order of priority:
 DID—When selected, enables Direct Inward Dialing to an endpoint.
 TCS4—When selected, enables TCS4 dialing. This setting does not
apply to voice calls.
 IVR—When selected, enables the Interactive Voice Response
operator.
 Default extension—When selected, enables the use of the default
extension number that you enter in the field.
6 (PRI Gateways only) Select the Overlap Receiving check box to enable
overlap receiving functionality. In this functionality, the Gateway can
receive consecutive digits until the dialing is complete, instead of
receiving the entire phone number as a block of digits. The Gateway
recognizes that an overlap receiving dialing is completed when it
receives a fixed, predefined, incoming number of digits. If the Gateway
receives a complete indication notification from the switch (PSTN) or a