User guide

Configuring the SCOPIA Gateway 145
Configuring Port Settings
3 Select the Enable check box.
4 In the Octet 3 field, choose a value. When the value is greater than 0,
that number of fields appears beneath the Octet 3 field. If this field is set
to 0, the Octet 3.1 and Octets 3.2 fields are not available. If this field is
set to 1, only the Octet 3.1 field is available.
5 In the Octet field(s), choose settings.
6 In the Type field, choose Binary feature or Binary service and then in
the Facility Coding Value field, enter a value.
—or—
In the Type field, choose Parameterized and then in the Parameterized
Field field, enter a value.
—or—
In the Type field, choose Custom and then in the Octet 4 and Octet 5
fields (if applicable), enter a value.
Note When you select Binary feature or Binary service in the Type field,
the Facility Coding Value field is for Octet 4, Bits 5-1. When you select
Parameterized in the Type field, the Parameterized Field field is for Octet 5,
Bits 7-1. When you select Custom in the Type field, the values entered in the
Octet 4 or Octet 5 fields are not subject to bit restriction.
7 Repeat step 1 for as many additional NSF information elements as
necessary.
DELETING ISDN
INFORMATION
E
LEMENTS
In the Advanced ISDN section of the PRI Port tabs, you can delete an ISDN
information element.
 Procedure
1 In the Gateway interface, on the sidebar, click Gateway (if not already
selected).
2 Click the applicable PRI Port tab.