User guide

132 SCOPIA 400/1000 Gateway User Guide

Configuring Port Settings

6 In the Signaling protocol field, select a signaling protocol for use in

call setup from the following list:

 RS-366—Carries signaling information only.

 Data Triggered—Enables the Gateway to connect a call when it

detects valid incoming data from an endpoint on the serial network.

 Manual Control—Enables an Administrator to manually connect a

call via the Gateway web user interface.

Different signaling protocols are available depending on the interface

and terminal adapter that you select, as shown in Table 3-19.

The Signaling protocol field is enabled only you select DTE in the

Interface field. The Signaling protocol field is set to RS-366 and

disabled when you select DCE in the Interface field.

7 In the Incoming default bandwidth field, set the rate to which the

Gateway forces the bandwidth of an incoming call. Available only when

DCE is selected in the Interface field.

8 (Optional) Click Connect Call/Disconnect Call to connect or

disconnect the specified call. Available only when Manual Control is

selected in the Signaling protocol field.

9 Click Reset.