User guide

Configuring the SCOPIA Gateway 129
Configuring Port Settings
7 In the Signaling protocol field, choose the signaling protocol used to set
up and tear down the calls through the signaling (D) channel.
Depending on the interface used, different signaling protocols are
available.
8 In the Network access field, choose the Gateway national access type:
TE (Terminal Equipment) or NT (Network Terminator) device.
9 In the Clock source field, choose the Gateway clock source:
 Master (the Gateway provides the clock signal)
 Slave (the Gateway receives the clock signal)
10 In the Line Build Out field, choose Long Haul or Short Haul.
Note You can configure this setting only if you select Japan in the Country
field. Skip to step 4 otherwise.
.
Related Topics
 Configuring Fractional Channels
 Configuring Line Coding, Framing and Signaling Type
CONFIGURING
FRACTIONAL
CHANNELS
In the Physical Interface section of the PRI Port tabs, you can configure
fractional channels as part of the physical line properties of the specified PRI
port.
 Procedure
1 In the Gateway interface, on the sidebar, click Gateway (if not already
selected).
2 Click the applicable PRI Port tab.
3 Click Physical Interface.
4 Click Fractional to select fractional channels.
The Fractional dialog box appears.
5 Select the Fractional line check box to enable the fractional selection of
channels.