User guide

128 SCOPIA 400/1000 Gateway User Guide
Configuring Port Settings
6 (PRI Gateways only—optional) Select the Strip Local Area Code
check box if you want the Gateway to strip local area codes for
outbound calls to the ISDN network.
Note The type of line connected to this PRI port appears in the Physical
standard field.
CONFIGURING PORT
PHYSICAL
INTERFACE SETTINGS
This section describes the available configuration options for Gateway ports.
 PRI Ports
 Serial Ports
PRI PORTS Note This section applies only to Gateway P20 SP.
In the Physical Interface section of the PRI Port tabs, you can configure the
physical line properties of the specified PRI port.
 Procedure
1 In the Gateway interface, on the sidebar, click Gateway (if not already
selected).
2 Click the applicable PRI Port tab.
3 Click Physical Interface.
4 Select the Same as Port check box if you want to duplicate physical
interface settings from another PRI port that you choose from the field.
When selected, you cannot modify any settings in this section.
Note This option is not available in Gateways that support only one PRI
port.
5 In the Interface field, choose the line interface: T1 or E1.
6 In the Country field, choose the nation where the ISDN service is
installed.