User guide

124 SCOPIA 400/1000 Gateway User Guide
About Gateway Services
The following topics discuss how you can configure services on the Services tab:
 Viewing Existing Services on page 124
 Adding or Editing Services on page 124
 Deleting Gateway Services on page 126
VIEWING EXISTING
SERVICES
The Services tab in the Gateway interface displays a list of currently defined
services for the Gateway in a table format with the following columns and fields:
 Prefix—Displays the prefix that identifies the service.
 Description—Description of the service.
 Call Type—Media type of the call.
 Bit Rate—Total bandwidth requested for the service.
 PRI Port 1 or 2/Serial Port 1 to 4—Indicates whether or not the service
is enabled for the specified port.
 Total—Displays the total number of services currently defined in the
Gateway.
ADDING OR EDITING
SERVICES
On the Services tab, you can add a new service or edit an existing one.
 Procedure
1 In the Gateway interface, on the sidebar, click Gateway (if not already
selected).
2 Click Services.
3 To add a new service, click Add. To edit an existing service, select it
and then click Edit.
4 In the Prefix field, enter or edit the prefix number of the service. The
prefix can be up to 31 characters long. Valid characters are 0 to 9 and
pound sign (#), asterisk (*), and comma (,).
Note Since the comma cannot be used in the Party number field of the MCU
Conference Control interface, we recommend that you do not use the comma
as a prefix in Gateway fields.
5 In the Description field, enter or edit the description of the service (up to
31 characters in length).