User guide

Configuring the SCOPIA Gateway 111
Configuring Gateway Settings
5 If you selected Independent at step 4, you need to assign a mode of
operation to each call leg, as follows:
In the ISDN (H.320) Mode and IP (H.323) Mode or Serial (H.320) Mode
fields, choose one of the following settings:
 No Encryption—Encryption support is disabled.
 Best Effort—The Gateway implements a “best effort” encryption
algorithm. If an endpoint supports encryption, it connects in an
encrypted way. If not, it connects without encryption.
 Encryption Required—The Gateway connects only AES 128
encrypted calls.
6 Click Upload.
CONFIGURING
ADVANCED
SETTINGS
In the Advanced section of the Settings tab, you can configure, enable, and
disable various advanced Gateway settings.
 Procedure
1 In the Gateway interface, on the sidebar, click Gateway (if not already
selected).
2 Click the Settings tab.
3 Click Advanced.
Table 3-12 explains the IP-to-ISDN (or Serial) call settings you can
configure in this section.
Table 3-13 explains the ISDN (or Serial)-to-IP call settings you can
configure in this section.
Table 3-14 explains the IP call settings you can configure in this section.
Table 3-15 explains the ISDN call settings you can configure in this
section
(available in PRI Gateways only).
Table 3-16 explains the general call settings you can configure in this
section.