User guide

Configuring the SCOPIA Gateway 101

Configuring Gateway Settings

CONFIGURING ALERT

INDICATIONS

In the Alert Indications section of the Settings tab, you can select which events

trigger Simple Network Management Protocol (SNMP) traps. You can also

define multiple SNMP servers to which the Gateway sends the SNMP traps.

Note The Gateway supports traps in the SNMPv1 format.

 Procedure

1 In the Gateway interface, on the sidebar, click Gateway (if not already

selected).

2 Click the Settings tab.

3 Click Alert Indications.

4 In the Events section, select events in the Disabled events field and click

Add to select an event to monitor. Or, select an event in the Enabled

events field and click Remove to remove that event from monitoring.

5 Select the Send SNMP Traps check box to configure the IP address of

the SNMP server to which the Gateway sends SNMP trap notifications

of the events selected in the Enabled events field. You can configure up

to three different SNMP trap servers.

6 In the Trap server IP and Port fields, enter the IP address and port

number for each SNMP server to which you want the Gateway to send

SNMP trap notifications. To remove an SNMP server, set the SNMP

server IP address to 0.0.0.0 and click Upload.