User guide

100 SCOPIA 400/1000 Gateway User Guide
Configuring Gateway Settings
 Procedure
1 In the Gateway interface, on the sidebar, click Gateway (if not already
selected).
2 Click the Settings tab.
3 Click Quality of Service.
4 In the Quality of service support field, select one of the following option
buttons:
 None—Select to disable quality of service support.
 Default (recommended)—Select to assign the default DiffServ
Code Point value for each media type.
 Custom—Select to assign your own DiffServ Code Point value for
each media type. You can configure the following additional
settings:
 In the Control Priority (0-63) field, enter a whole number from
0 to 63 to set the DiffServ Code Point value of signaling packets
that the Gateway sends out. The default value is 26.
 In the Video Calls section Voice Priority (0-63) field, enter a
whole number from 0 to 63 to set the DiffServ Code Point value
of voice packets that the Gateway sends out. The default value
is 46.
 In the Video Priority (0-63) field, enter a whole number from 0
to 63 to set the DiffServ Code Point value of video packets that
the Gateway sends out. The default value is 34.
 In the Data Priority (0-63) field, enter a whole number from 0
to 63 to set the DiffServ Code Point value of data packets that
the Gateway sends out. The default value is 26.
 (PRI Gateways only) In the Voice Calls section Voice Priority
(0-63) field, enter a whole number from 0 to 63 to set the
DiffServ Code Point value of voice packets that the Gateway
sends out. The default value is 46.
Note You can click Restore Defaults to restore all default settings.