User guide

'Initial Configuration' | 47
RADVISION | Administrator Guide for SCOPIA XT1000 Version 2.0
Step 5 If a gatekeeper is not present in the network, report the IP number of the gateway. If a gatekeeper
is present, this number is not needed.
Note: In Solution mode (when a gatekeeper and iVIEW are available), the Codec Unit must be
registered with the gatekeeper.
Step 6 After this setup, the user can easily place an ISDN call (as explained in the User Guide).
Figure 2-10 Basic Call
If the user wants to change the Rate of the call, he may use the Advanced Options page in the
Direct Call GUI, and select the pre-defined rate. When the SCOPIA gateway is used, the Codec
Unit will automatically detect the rate used to place the call.
Figure 2-11 Advanced Call