SDS

SAFETY DATA SHEET
PRODUCT NAME: LastiSeal® Brick & Concrete Sealer | FLAT
PRODUCT USES: Penetrating clear sealer for concrete, bricks, pavers, masonry, and porous building materials. Waterproofs,
strengthens, and protects against capillary water seepage, freeze-thaw, deicing chemicals. Driveways, pool decks, patios,
stairs, ramps, decks, CMU walls, chimney, restoration of historical buildings, statues or monuments, and paint primer.
PREVENTION P280: Wear protective gloves, clothing, eye protection.
P261: Wash hands thoroughly after handling.
P264: Avoid breathing mist/spray.
GENERAL P102: Keep our of reach of children.
CODE HAZARD STATEMENT HAZARD CLASS CATEGORY SIGNAL WORD
NONE NONE NONE NONE NONE
MANUFACTURER:
Novion, Inc.
494 Bridgeport Avenue
Suite 101 336
Shelton, CT 06484-4784
USA
EMERGENCY PHONE NUMBER:
PERS Professional Emergency Response Service
Company Code 10492
1-800-633-8253 (U.S. and Canada)
1-801-629-0667 (International)
Read before use.
!
SDS
SECTION 1: PRODUCT IDENTIFICATION
SECTION 2: HAZARD IDENTIFICATION
SECTION 3: COMPOSITION/INGREDIENT INFORMATION
PRECAUTIONARY STATEMENTS
symbol
INGREDIENTS CONCENTRATION OSHA PEL ACGH TLV
NONE TO REPORT — — —
RESPONSE P301+P312: IF SWALLOWED. Call a POISON CENTER or physician if you
feel unwell.
P304+P340: Absorb spillage to prevent material damage.
P305+P351+338: IF IN EYES: Rinse cautiously with water for several minutes.
Remove contact lenses, if present and easy to do. Continue rinsing.
P332+P313: IF SKIN irritation occurs: Get medical advice/attention.
P362: IF EYE irritation persists: Get medical advice/attention.
l a s t i s e a l
®
PAGE 1 of 2
EYES: Flush eyes with water for several minutes. Hold eyelids open during rinse. Remove contact lenses. Seek medical attention is irritation continues.
SKIN: Wash affected skin areas thoroughly with soap and water. Remove contaminated clothing and wash before reuse.
INGESTION: Low ingestion hazard. May cause nausea. Drink large volumes of water. Seek medical attention if symptoms develop.
INHALATION: Avoid breathing mist. May cause respiratory irritation. If irritation occurs, move to a fresh air environment. Seek medical attention if irritation continues.
SECTION 4: FIRST AID MEASURES
SECTION 5: FIRE FIGHTING MEASURES
SECTION 7: HANDLING AND STORAGE SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
SECTION 6: ACCIDENTAL RELEASE MEASURES
*Product is non-flammable and non-combustible. Under normal conditions of use, this
product will not cause or support fire. If fire occurs, use control measures for surrounding
materials. This product is compatible with all extinguishing media.
• DO NOT STORE IN DIRECT SUNLIGHT. Do not store at
temperatures above 100 °F or below 40 °F. Protect from freezing.
• Keep container sealed when not in use. Mix thoroughly before use
and periodically during use.
Contain and absorb spill. Wash area with soap and water. Product dries to form a thin
glass film. Dispose of response equipment and debris in accordance with applicable
regulations. Prevent entry into waterways or sewers.
SKIN CONTACT: Wear appropriate protective clothing to prevent repeated
or prolonged contact.
INHALATION: Ensure adequate ventilation to keep mist to a minimum. If
specific application requires respiratory protection, an appropriate
NIOSH/MSHA approved respirator should be used.
PROTECTIVE EQUIPMENT: Wear gloves, eye protection, and clothing to
minimize skin contact.
NONE