Installation Guide

ManualsBrandsRadonAway ManualsOtherComplete Fan Cover in Black

FLOW

TRANSITION FITTING

FLEX COUPLING

FAN HOUSING

FAN

FLOW

FLEX COUPLING

BASE PLATE

OPTIONAL

CONDENSATE

KIT (25030)

3 ⅝ for 3” DIA PIPE

2 ⅝ for 4” DIA PIPE

6 ⅜

Fan Cover (Housing) Kit Installation Instructions

Install:

1. Run PVC pipe through side wall before mounting fan housing. NOTE: Do

not cut PVC for length until reading step 4. Decide where the electrical

cord will run and drill necessary holes.

2. Cut a hole in the bottom of the base plate no more than 3/4” from the

extreme bottom end.

3. Mount base plate on the wall, over the PVC pipe, with supplied screws, or

if necessary eld supplied anchors.

4. Cut the PVC pipe off so that

3 5/8” (for 3” dia pipe) or

2 5/8” (for 4” dia pipe) of pipe extends through the baseplate.

5. Fit street elbow to pipe coming through the wall. Cement in place after t up

is checked. Verify that the center line of the Street 90 is 6 3/8” from the

baseplate, level and plumb.

6. Fit lower ex coupling (4x6 for GP series fans) over elbow. Fit fan inlet

onto lower ex coupling.

7. Attach bottom of transition tting into top ex coupling.

8. Fit top ex coupling onto fan outlet.

9. Install vertical outlet pipe into outlet of transition tting. Cement in place.

10. Fit housing over outlet pipe; secure to baseplate with supplied screws.

PARTS NOT INCLUDED:

PVC Pipe

PVC Street 90° Elbow

Radonaway Fan

Flexible Couplings (2)

PVC cement

Condensate Kit (P/N 25030)

NOTE:

If painting is desired, prime with ‘exible parts

primer’ (available at most auto paint supply

stores). Color coat by following instructions

shown on primer.

For use with fans with a diameter up to 12.5” and a height no greater than 13.5”.

IN083 rev A

Kit Includes:

Baseplate

Transition Fitting

Fan Housing

12 screws to attach Base to wall & Housing to Base