User manual

Electromagnetic Interference (EMI) is any signal or emission, radiated in

free space or conducted along power or signal leads, that endangers the

functioning ofa radio navigation or other safety service or seriously

degrades, obstructs, or repeatedly interrupts a licensed radio

communications service. Radio communication services include, but are

not limited to, AM/FM commercial broadcast, television, cellular services, r

adar, air-traffic control, pager and Personal Communication Services (PCS).

These licensed services, along with unintentional radiators such as digital

devices, including computers, contribute to the electromagnetic environment.

While this device has been designed and determined to be compliant with

regulatory agency limits for EMI, there is no guarantee that interference will

not occur in a particular installation. If this equipment does cause interference

with radio communication services, which can be determined by turning the

device off and on, you are encouraged to correct the interference by one or

more of the following measures:

• Re-orient or relocate the receiving antenna.

• Relocate the device with respect to the receiver.

• Increase the separation between the equipment and receiver.

• Connect the equipment to an outlet on a circuit different than that

to which the receiver is connected.

• QUALIFIED SERVICE – All service must be performed by the factory or

by a certified CR Pro field service engineer. There are no user replaceable

parts inside the CR Pro. DO NOT remove the covers as internal parts may be

damaged, the warranty will be voided and it may be hazardous to your health.

• SPACE REQUIREMENTS – The CR Pro has dimensions of

26.5in(67.3cm)(w) x 21in( 53.9cm)(d) x 42in(106.7cm) (h). An additional 36 in

(92.3 cm) of space should surround the CR Pro to provide access and

working space for documents and plate cassettes.

• POWER REQUIREMENTS –

The AC outlet should be dedicated to the CR Pro (no other devices

connected to this circuit) to prevent the possibility of injected line noise by

other devices.