Installation guide

36
Table 2 – Hardware Specifications
Phosphor Plate Phosphor Plate
8” X 10”
(203.2mm X 254.0mm)
10” X 12”
(254.0mm X 304.8mm)
14” X 17”
(355.6mm X 431.8mm)
14” X 34”
(355.6mm X 870.4mm)
Cassette
9” x 11” (228.6mm X 279.4mm)
11” x 13“ (279.4mm X 330.2mm)
15” x 18” (381.0mm X430.8mm)
15” x 35.5 (381.0mm X 901.7mm)
Scan time Scan Scan and Erase
8” x 10” 12.24 seconds 24.48 seconds
10” x 12” 18.36 seconds 37. 12 seconds
14” x 17” Plate 26 seconds 52 seconds
Interface USB or Ethernet
Dimensions 22”(w) x 21”(d) x 40”(h)
Weight 198 lbs.
Power Input voltage 100 to 120 VAC, 57 to 64Hz or
200 to 230 VAC, 47 to 54Hz
Input current 3.2A for 115 VAC 60 Hz
0.9A for 230 VAC 50 Hz
Internal voltage/current +5 V at 10A max
+12 V at 1A max
-12 V at 1A max
+24 V at 5A max
Laser Type Solid State
Power 125 mw
Resolution Spatial 2800 pixels over a 14.2 inch scan line
Grayscale 16 bits
Optical Density
range
0.00 to 4.00 Transition
of density
5 pixels or less
Signal-to–noise
ratio
4 to 1 at 0 to 4.0 Optical
Density
0.001 O.D. at density 1.5 O.D.
0.01 O.D. at density 2.5 O.D.
0.1 O.D. at density 3.5 O.D.
Geometry one pixel of true position over entire
film
Output format (All scan modes) 16 bit (65535 grayscale) max