Installation guide

32
10. Wipe the surface of the phosphor plate in the long direction with
overlapping stokes. Rotate the cleaning cloth to use a clean section as
you progress across the plate (see photo #4). NOTE: do not use a
circular motion when cleaning the plate as this may drag
contamination from the un-cleaned area of the plate back on to the
surfaces that have just been cleaned.
Photo 4
11. Inspect the phosphor plate for any remaining foreign material; repeat the
cleaning process as necessary.
12. Inspect the phosphor plate for damage such as deep scratches, dents,
etc. If physical damage is observed, contact Radlink Customer Support.
13. Carefully reinsert the phosphor plate into the cassette.
14. Inspect the “Snap-Lock” retaining clip on the cassette. The clip should
retain the plate firmly. If the clip is bent or does not properly retain the
plate, contact Radlink Customer Support.
Wipe in this direction