Installation guide

15
4. Start Calibration
From the application Click Manage  CR Setup  Calibrate. (Figure 5)
The calibration process should take 3-4 minutes to complete.
5. Calibration - The CR Pro will scan the exposed plate in order to calibrate
the intensity to allow for the best possible images to be acquired from the
plate. Once scanned, the system will then go through a
second pass and erase the plate to normal levels. The
calibration process will take approximately 4 minutes. Do not
remove the cassette until calibration has been completed.
Note that if the cassette has not been exposed correctly an
error message will display (Figure 6).
6. Finished – The CR Pro is now calibrated and you can begin using it for
processing exposed plates. (To verify that the calibration has completed a
message will display in lower left hand corner. Scanner status bar will
display Scanner ready and turn green.)
Figure 6
Figure 5