Installation guide

9
Hardware Installation
1. Place the CR-Pro on a solid flat, leveled surface.
2. Plug the power cord to the AC Power Adapter located on the back of the
CR-Pro. (Figure 1)
3. Plug the end of the power cord to an available power outlet. A UPS/Line
conditioner is recommended. It is desirable to have the CR-Pro on an
isolated circuit to avoid conducted noise from other devices affecting the
quality of operation.
4. Plug one end of the Ethernet cable (Cat5/6) into the CR-Pro Ethernet port
(see Figure 1). Note: Do not route the Ethernet cable and the power cable
in close proximity as power cable radiation may affect transmission of
data.
6. Turn the Power ON/OFF switch on the back of the CR Pro to ON (see
Figure 1)
.
USB Port
Ethernet Port
Power ON/OFF Switch
AC Power Adapter