System information

Version 1.0 Page 25
GB
Installing Your Receiver
5 Installing Your Receiver
CAUTION:
Do not place the receiver near any heat sources or in strong sunlight.
Protect all cables from damage caused, for example, by sharp edges.
This appliance must only be used with a mains voltage of 230 V (± 10%), 50 Hz.
CAUTION:
Do not connect the receiver to the mains until you have correctly connected your
VCR, TV and any other analogue receiver you may have to the mains.
• Use double shielded coaxial cable for connecting the LNB to the receiver.
CAUTION:
When assembling the F-type connector, make sure that no part of the inner wire-
mesh sheath touches the inner core (see diagram below). Failure to do so can
cause a short-circuit and damage your receiver.
Core
Bent Wire
Wire mesh
• Tighten the safety nut on the F-type connector by hand only. Do not over
tighten!
The receiver is pre-programmed at our factory to immediately provide you with
hundreds of different channels. Of course you can change these channels or re-
place them completely. In order to take advantage of all of the user guides such as
programme, you will need to make a number of settings which are described in
the following chapters.