Instruction manual

Version 1.0 Page 27
GB
Enter the three-digit code using the number keys. If your device switches off, your
remote control is ready to use.
Step 4: Press the SET key to store the settings. The LED will blink three times.
If this does not happen, repeat steps 1 to 4.
Method 2: Systematic Search
Step 1: Press and hold down the SET key for approximately three seconds
until the red LED lights up.
Step 2: Press one of the following device keys to set the desired device.
SAT Analogue Receiver
DVB Digital Receiver
TV Television
VCR Video Recorder.
Step 3: Switch on your device.
Point the remote control at the device.
Press the Power key repeatedly until the device switches off.
NOTE:
Many devices do not switch off immediately - you should wait briefly before
pressing the Power key again.
Step 4: Press the SET key to store the settings.
The LED will blink three times.
If this does not happen, repeat steps 1 to 4.
When you have finished:
• Press the blue key for the device you want to operate.
• When the LED flashes quickly, you can use the remote control as normal.
Programming Your Remote Control
…