Specifications

Configuring the BIOS Setup
Page 5
22
Use the up and down cursor (arrow) keys to move from field to field. For most
fields, once the cursor is positioned at the field, pressing the left and right cursor
(arrow) keys will scroll through the available choices. Once the screen has been
changed to appear as you desire, press the F10 function key to save the changes in
battery-backed CMOS RAM. Then press the F5 function key to confirm the changes
and reboot, F1 to confirm changes but not reboot or ESC to ignore any changes and
exit.
Each field is explained below.
Date and Time
These values are changed by moving to them and typing in the format shown.
Configuration Errors
This field provides several choices about the situations under which the BIOS should
wait for user input if a configuration error is found. The selections are:
1) Halt on all errors
2) Ignore all errors
3) Ignore keyboard errors (allows operation without a keyboard)
4) Ignore disk errors
5) Ignore keyboard and disk errors
Diskette Drive
This field gives you several choices about the type of floppy disk drives installed as
the A and B drives. Toggle the entry to match the type of diskette drive(s) attached.
If no floppy drive is attached, select NONE for each diskette drive field.
Fixed Disk Drive
This display-only field shows the type of disk selected from the fixed disk menu.
Possible values are None, AT and EXM FLASH. To see the detailed characteristics
of the device or to change the device, use the F3 function key to go to the fixed disk
menu. See the section Fixed Disk Menu, page 7.