Specifications

22
Getting Started
Page 31
sectors to choose from.
Destination Address:
This field identifies where in conventional memory the BIOS
extension will be copied. Although the boundaries are 8KB in the
FBD, the target area has 16KB granularity. If only a single 8KB
region is copied, it consumes 16KB in the target.
BIOS Extension Size:
This field checks for the number of bytes to copy. Anything copied
in this menu will supersede all ISA shadowing setups. Check to
make sure you are not locating an embedded BIOS extension in the
same address as an ISA BIOS extension.
NOTE: The factory has installed two optional BIOS extensions in
the FBD. The PhoenixPICO Flash RFA BIOS extension is located
at 4C000H. The Phoenix PicoCard BIOS extension is located at
4A000H.
To boot from a factory prepared RFA, use these parameters:
Offset of BIOS extension in FBD [4C000H]
Destination Address [D0000H]
BIOS extension size [4000H]
To boot from a factory-prepared FLASH or ATA card:
Offset of BIOS extension in FBD [4A000H]
Destination Address [C8000H]
BIOS extension size [2000H]
To boot PICO flash, follow the instructions in Appendix F for disk
(RFA) preparation. Use the DOS command SYS d: to install a boot
image on the RFA. In CMOS,
Offset of BIOS extension in FBD [4C000H]
Destination Address [D8000H]
BIOS extension size [4000H]