Specifications

22
Getting Started
Page 22
Note that autotyping may change this value if the hard disk
reports that it supports LBA. The default is disabled.
Transfer Mode
This option selects the mode that the System BIOS uses to
access the hard disk. The only available selection is:
Standard (default)
Note that autotyping may change this value depending on
the transfer modes that the hard disk reports it supports.
Once you have set up the IDE Adapter 0 Master, if
necessary you can set up an IDE Adapter 0 Slave. The
default setting is None.
When you complete entries to the IDE Adapter Sub-
menus, exit to the Main BIOS Setup Menu using the ESC
key.